BYD ATTO 3 2023 - Page 91

DC charging is achieved by connecting
the vehicle to a DC charger via its
connector.
●
Unlock the charge port door, then
open the port door and cap.
●
Connect the vehicle port:
●
Plug the connector into the port,
making sure it is tight.
●
Operate the charging equipment to
start charging.
●
The charging connection indicator
lights up on the instrument cluster.
●
In the charging process, the instrument
cluster or infotainment touchscreen
displays relevant charging parameters
and the charging sign.
3. Stopping charging
●
End the charging:
●
Charging ends automatically when
early stop time is due or the charging
is complete. You can end charging
through charging app or swiping
card.
●
Double-pressing the unlock button
of driver's door or on the smart
key within three seconds to stop
charging.
●
When the DC charging pile charging
is complete, organize the charging
equipment and store the charging
connector in its designated position
properly.
●
Reinsert the DC charge cap and close
the port door.
REMINDER
●
When the port cap is fully open,
do not close the charge port door.
CAUTION
●
If the charging connector cannot
be removed after unlocking,
try a few more unlocking
attempts. If that does not work,
try emergency unlocking. For
the operating procedure, see
"Emergency Unlocking of the
Charge Port" in "Charge Port Anti-
theft Lock".
●
To unlock the charge port after DC
charging, press the unlock button
twice within three seconds for the
operation to be successful.
●
See the charging instructions for
speci󽗉c charging precautions.
WARNING
●
See section "Charging
Instructions" for charging safety
warnings.
Intelligent Charging
●
When the manager detects that the
low voltage battery capacity is low, the
low voltage battery can be charged
by the high-voltage battery, so it is
normal that the SOC and driving range
displayed decrease when the vehicle is
powered on after an idle period.
90