BYD ATTO 3 2023 - Discharging Device

REMINDER
●
When the vehicle lies idle for
long periods, it is normal that
intelligent charging takes place.
●
Power for intelligent charging
comes from the high-voltage
battery pack, so it is normal that
an SOC decrease is noticed when
the vehicle is powered on.
Discharging Device*
●
This vehicle features a vehicle to load
(V2L) function.
WARNING
●
Do not touch any metal terminal
of the discharging socket, in-
vehicle discharge socket, or
vehicle charge port during
discharging.
●
Stop discharging immediately if
there are any abnormalities such
as peculiar smell and smoke.
●
See "Charging Instructions" for
charging safety warnings.
●
Store the product in a cool and
dry place when it is not in use.
●
When charging, do not place the
equipment in the trunk, under the
front of the vehicle, or near the
tires.
●
When using the equipment,
prevent it from getting rolled
over by the vehicle, dropped, or
trampled on.
●
Never drop the equipment or
move it by pulling it directly by
the cable. Take caution when
moving the equipment.
WARNING
●
Never use the discharging device
if the power strip cable becomes
soft, the charging connector cable
is worn out, the insulation layer
is cracked, or any other damage
occurs.
●
Never use the device when the
discharging connector or power
strip is disconnected or broken, or
when there is any sign of surface
damage.
CAUTION
●
For precautions concerning use of
the discharge connection device,
please refer to the precautions for
charging equipment included in
item 3 of "Charging Precautions".
●
Before discharging, please
con󽗉rm the vehicle SOC and
estimate the remaining driving
range.
REMINDER
●
The V2L function is recommended
only when SOC is high.
●
The V2L function is restricted
when the vehicle SOC is low.
Discharging
Discharging
●
Before discharging, turn o󽗈 the anti-
theft mode of the vehicle.
●
Unlock the charge port door switch,
then open the port door and cap.
●
Check before discharging:
91
04
USING AND DRIVING