●
Ensure that the battery capacity of
the vehicle to be discharged is not
below 15%.
●
Ensure the V2L connection device
casing is not cracked, and its plug is
free from rust or obstructions.
●
Ensure that there is no water or
foreign material inside the charge
port and that metal terminals are
not damaged and free from rust or
corrosion.
●
Do not discharge if any of the above
conditions is found; otherwise, short
circuit or electric shock so caused
could lead to personal injury.
●
Connect the discharge connection
device:
●
Connect the V2L discharge device
to the charge port. The power strip
indicator lights up when the strip is
powered and ready for use.
●
Discharging starts:
●
After the connection is made,
discharge begins and respective
information is displayed on the
instrument cluster.
Stopping discharging
●
Stop discharging:
●
Disconnect the load.
●
Disconnect the discharge connection
device:
●
Unplug the discharging device.
●
Close the charge port cap and the
port door (see instructions for Mode
2 charging).
●
Organizing the equipment:
●
Store the equipment properly when
discharging is complete.
Charge Port Anti-theft
Lock
●
In order to prevent the charging
connector from being stolen, the
vehicle charge port is anti-theft during
charging and discharging. The anti-
theft function is disabled by default.
To enable the function, go to the
infotainment touchscreen →
→
New Energy → Charging Settings.
●
When the function is enabled, unlock
the vehicle and unplug the charging
connector during charging in the
following ways:
●
When it is on OFF status, press the
unlock button on the smart key to
unlock.
●
Press the microswitch next to the
exterior handle of the driver's side
door to unlock (with the smart key
nearby).
●
Press the central unlock button
under the window on the driver's
door to unlock.
CAUTION
●
After unlocking the charging
connector, it can be pulled out
within 30 seconds. After 30
seconds, it will lock again.
92
To Next Page
Loading...
