F3/F3R OWNER’S MANUAL
- 34 -
selected, the system will set the time to be 15
seconds automatically.
Steps for changing optional functions
1. Check whether the anti-theft system is
released.
2. Close all of the doors.
3. Insert the key into the ignition switch.
4. Open and close the driver’s door twice
within 10 seconds. (close→
open→close→open→close)
5. Turn the key from “ACC” to
“ON” three times. (ACC→ON→ACC→ON
→ACC→ON→ACC)
Now the anti-theft indicator light
illuminates.
6. Press the “LOCK” switch on the wireless
remote control according to the following
tables, and make sure that the indicator
flashes.
Make sure the function state by pressing the
“LOCK” switch on the wireless remote control.
While the function is chosen, the turn signal
light will flash once and you can hear the
warning sound once. To desele
ct this
function, open any a door and close it. If you
find the turn signal
light flash twice hear the warning sound twice,
it indicates that the function is disabled. If
failed, re-open the door and close it again to
exit
from disabled state to enabled state.
Press
LOCK
Optional function
once Automatic setting
functions
twice Automatic locked and
unlocked
3 times On-board light system
4 times Starting 6 cycles warning
5 times Starting 9 cycles warning
6 times The delay time of
entering the vehicle:15s
7 times The delay time of
entering the vehicle:30s
8 times Knocking sensitive
standard
To Next Page
Loading...
