BYD G3 AUTO - Engine Starting Procedures

BYD G3 AUTO Owner’s Manual
85
- start the engine and run idle for at least
10 seconds (during engine starting, the
noise of air flow in circulating in the
system is normal). ）
- Shift gear shifting lever to other gears
(P gear – R gear – D gear), waiting for
at least 5 seconds before shifting gear.
- Shift to “D” (Driving) gear.
- Release foot brake pedal.
- Slow down the vehicle to a minimum of
60km/h (engine speed shall not be
over 2500 rpm).
- Release the accelerator to let the car
slow down until stop (noise caused by
air flow circulation since engine
starting disappears).
- Warm up the oil by driving the car for at
least 5 minutes or until the
transmission oil temperature reaches
60℃.
- Park the car on flat ground or slope.
- Step on foot brake pedal.
- Wait for 2 seconds.
- Shift gear to “N” (Neutral) gear.
- Wait for 10 seconds.
- Shift gear to “P” (Parking) gear.
- Let the engine run idle.
- Pull off oil level plug screw.
- Make sure at least 0.2L oil flows out
after removing the oil level plug screw.
(If the oil outflow is less, it means the
original oil amount is insufficient.)
- Wait for a few minutes until the oil
droplet falls off from the plug screw
opening.
- Reinstall the oil level plug screw.
- Shut down the engine.
Note: During refilling transmission oil,
prevent it from overflow. In Case of
overflow, clean up overflowing oil
immediately
Drain
plug (1)
Oil level
plug (2)
Oil filling
p
lu
g
(
3
)