BYD SEAL 2023 - Page 127

with doors unlocked, the system keeps
indic
ators on side mirrors solid on to
warn the driver if moving objects, such as
bicycles or automobiles, approach from
behind on an adjacent lane. If the driver
attempts to open the door at this time,
indicators on side mirrors begin to 󽗊ash
and a chime sounds.
Function Button Operation
●
To enable or disable BSD, RCTA, RCTB,
RCW and DOW, go to Infotainment
touchscreen
→ ADAS → Active
Saf
ety → Blind Spot Assist. When the
vehicle is started, the system defaults
to previous settings.
●
When the blind spo
t assist system is
disabled, no relevant indicators are
displayed on the instrument cluster.
●
When the blind spot assist system
is standing by, if vehicle conditions,
such as speed or gear status, do not
meet the requirements of any function,
is displayed on the instrument
clus
ter and blind spot assist will not be
activated.
●
If the blind spot assist system
malfunctions,
is displayed on the
ins
trument cluster.
●
When the blind spot assist system
is active,
is displayed on the
ins
trument cluster, meaning that the
function has been activated and can
trigger alarms at any time.
Precautions
●
While the B
SD system provides
assistance in monitoring blind spots
of rearview mirrors, it cannot replace
the driver's observation and judgment.
The driver must keep control of vehicle
at all times and drive properly and is
fully responsible for the vehicle.
●
The BSD system may be unable to
provide adequate warning on target
vehicles approaching from behind at a
high speed.
●
The driver must ensure the normal
operation of the BSD system, keeping
its rear corner mmWave radars in good
condition. For example, dirt, snow, or
other obstructions need to be cleared
right away.
●
The BSD system gives a warning if
unrelated targets at the rear side or in
the rear (such as work zone barriers,
large roadside billboards, re󽗊ectors
in tunnels, or other objects with a
large radar cross section) are wrongly
selected as target vehicles.
●
Detection may be a󽗈ected or delayed
in some environments. If the radar
cross section of the target vehicle is
too small (a bicycle, electric moped or
pedestrian, for example), the system
may fail to identify targets, leading
to false alarms. In addition, detection
may also be a󽗈ected or delayed by
noise or electromagnetic interference.
System Limitations
●
Under some circumstances, it is
di󽗋cult for the system to assist the
driver, and detection may be a󽗈ected
or delayed. Possible circumstances
include, but are not limited to:
●
The vehicle coming from behind
changes the lane suddenly.
126