BYD SEAL 2023 - Head-up Display (HUD)*

●
V
ehicles coming from behind are
detected too late at sharp turns,
slopes, or other settings.
●
The target vehicle is obscured.
●
Vehicles come from behind at a
relative speed above 80 km/h.
●
The vehicle is on a curve which is
too sharp, or is entering or exiting a
curve.
●
The vehicle is running under severe
weather, such as rain or snow.
●
Rear corner mmWave radar(s) come
o󽗈, are loosely installed, or are
blocked.
●
The vehicle encounters certain metal
guardrails or similar road conditions.
●
Targets that may not be responded
include, but are not limited to,
pedestrians and animals.
●
The environment contains
electromagnetic interference or
other in󽗊uences.
●
Vibration or collision in󽗊uence on
sensor calibration of BSD's rear corner
mmWave radars can degrade system
performance. If this is detected,
contact a BYD authorized dealer or
service provider.
WARNING
●
Blind spot assist only serves as a
driver assistance function, so the
driver must be fully responsible
for driving safety.
●
In󽗊uence of weather, road
conditions, and other factors may
cause blind spot assist to fail.
●
Use blind spot assist based on
your needs, tra󽗋c, and road
conditions.
Head-up Display (HUD)*
He
ad-up display (HUD): The head-up
display (HUD) function projects important
information, including vehicle speed,
speed limit, ACC, lane departure, BSD,
etc., into the driver's 󽗉eld of view on
the front windshield. It improves driving
safety by preventing the driver from
frequently changing the focus of eyes.
How to Use
●
To enable or disable HUD, go
to infotainment touchscreen →
→Vehicle Settings.
●
B
y factory default, HUD is on and the
image is displayed. When it is disabled,
no HUD image is displayed. The system
defaults to the previous settings when
the vehicle starts.
●
Height adjus
ting: adjust the height of
HUD virtual image in between -10 and
10. A total of 21 values are available,
and the default value is 0.
●
Brightness adjusting: adjust the
brightness of HUD virtual image in
between 1 and 11. A total of 11 values
are available, and the default value is
6.
●
Whirling adjusting: adjust the angle of
HUD virtual image. A total of 11 values
are available, and the default value is
0°.
●
Mode setting: select Classic (default
setting) or Snow mode according to
the environment of the vehicle.
127
04
USING AND DRIVING