Children should sit comfortably and
saf
ely. Make sure that the child restraint is
positioned, mounted, and used correctly.
Important considerations for selecting
a child restraint system
●
The child restraint system is the correct
type and size for the child.
●
The child restraint system is the correct
type and size for the seating position.
●
The child restraint system must be
homologated by ECE R44/ECE R129.
Child Restraint System Anchorages
Rear outboard seat
●
The anchorage is provided on the
rear outboard seat, and it will
only be visible after pressing its
decorative cover (the label showing the
anchorage is attached to the seat).
●
Anchor support
s (for the top tether)
are provided at the rear outboard seat.
CAUTION
●
Secur
e the top tether when
installing the CRS.
Installing Child Restraint Systems
Pr
ecautions
① Do not turn the anchorage lever trim
cover outward.
② Push the anchorage lever trim cover
inward in use.
③ Press the upper part of anchorage lever
trim cover to reset after use.
Installing child restraint systems:
1.
Open the anchorage lever trim cover
and install the child restraint system to
the seat.
24
To Next Page
Loading...
