BYD SEAL 2023 - Page 26

REMINDER
●
The anchorage lever is located on
the bevel at the rear end of the
seat cushion. It is visible when the
lower part of the child seat trim
cover is pressed. After the child
seat is removed, the upper part of
its cover needs to be pressed to
return the cover.
WARNING
●
When using the lo
wer anchoring
device, make sure that no foreign
objects are around the anchoring
device and that the seat belt is not
stuck behind the child seat; make
sure that the CRS is securely 󽗉xed.
Otherwise emergency parking or
an accident may result in serious
injury to the child or even death.
2. Open the anchor support c
over.
3. Fasten the snap hook to the anchor
support and tight
en the top tether to
ensure the strap is buckled securely.
① Top tether
② Anchor support
③ Snap hook
REMINDER
●
If the CR
S is equipped with a top
tether, secure the tether to the
anchoring device.
CAUTION
●
Push/Pull the child se
at in
di󽗈erent directions to ensure it is
securely installed.
●
If the driv
er seat obstructs the correct
installation of the CRS, install it on the
left rear seat.
Always follow the instructions below
when using a child restraint on a rear
seat:
●
When installing the child restraint
system on the rear outboard seats, if
there is no front passenger, the front
passenger seat can be adjusted to
make sure there is enough space for
the rear child seat.
●
The head support can be adjusted
or even removed to ensure that the
vehicle seatback can safely support the
child restraint system.
●
When a child restraint is without
seatback, never remove the head
support from the vehicle and adjust it
to locking position.
25
01
SAFETY