EasyManua.ls Logo

BYD SEAL 2023 - Page 41

BYD SEAL 2023
211 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
REMINDER
braking at this time can render
the vehicle unstable, given the
malfunction of ESC system.
Driving power limit warning light
When the po
wer of the vehicle is
limited, this indicator will come on.
In this case, contact a BYD authorized
dealer or service provider in time.
Headlight fault warning light
When the w
arning light is yellow, it
indicates the headlight is faulty, and it
is recommended to bring the vehicle
to a BYD authorized dealer or service
provider for inspection.
Blind spot detection (BSD)
indic
ator
When this indic
ator is on, it is
recommended to bring the vehicle to
a BYD authorized dealer or service
provider for inspection.
Main alarm indicator
If this indic
ator goes on, check the fault
prompt or warning on the instrument
cluster.
Driver attention warning (DAW)
light
Driver attention warning (DAW) system
evaluates the driver's degree of fatigue
by the vehicle operation status. The
driver would be reminded according to
the evaluation results to ensure driving
safety.
CPD indicator/warning light*
CPD indic
ator*: If child presence
detection (CPD) is turned o󽗈, the
indicator is solid on, and the OFF
reminder lasts for 󽗉ve seconds. Tap ON
or Delay. The indicator turns o󽗈 and
CPD is enabled.
CPD warning light*: If the CPD fault
reminder lasts for 󽗉ve seconds and
the indicator is solid on, it indicates
that the CPD system fails. It is
recommended to bring the vehicle to
a BYD authorized dealer or service
provider for inspection.
Seat belt reminder indicator
With the ignition swit
ched on, if any
passenger on the front seats or rear
seats* has not buckled up, the seat belt
reminder indicator lights up. It remains
on until the seat belt is fastened.
Airbag fault warning light
With the ignition swit
ched on, this
warning light turns on and then
goes o󽗈 in a few seconds if the
airbag system is working properly. This
warning light is used to monitor the
airbag ECU, collision sensors, in󽗊ation
device, warning lights, connections,
and power supply.
If any of the following cases occurs, it
means there is a fault in components
monitored by the warning light system.
In that case, contact a BYD authorized
dealer or service provider for vehicle
inspection as soon as possible.
When the ignition is switched on, this
warning light remains o󽗈 or is solid
on after the ignition is switched on.
40

Table of Contents

Other manuals for BYD SEAL 2023

Related product manuals