BYD SEAL 2023 - Page 78

●
Mode 2 char
ging means charging
with an AC charging connector that
complies with local standards. It is
recommended to use the dedicated
AC lines and power sockets meeting
local standards to avoid line damage
and protective trip due to high-power
charging, a󽗈ecting the normal use of
other equipment.
●
Avoiding damage to the charging
equipment (precautions for charging
equipment):
●
Prevent the charging equipment
from su󽗈ering any mechanical
impact.
●
Do not place the charging equipment
near heaters or other heat sources.
●
Before charging:
●
Make sure that the charging
connector and charge port are
free of foreign objects, and that
the protective cap of the charging
connector terminal does not get
loose or deformed.
●
Hold the charging connector, align
the connector with the charge port
and push it in, making sure that they
are properly connected.
●
When charging is complete:
●
Stop charging 󽗉rst and make sure the
charge port is unlocked.
●
Pull the charging connector.
●
Do not force the charging connector
out while the charge port is locked,
otherwise the charge port may be
damaged.
●
Switch the ignition o󽗈 before charging.
●
Precautions:
●
The vehicle can be powered on to use
the A/C while charging. To ensure the
charging power, it is recommended
to turn o󽗈 the A/C.
●
The v
ehicle should be parked in a
ventilated area, and there should not
be any occupant inside when charging.
●
The vehicle system automatically
stops charging when the high-voltage
battery is fully charged.
●
To stop AC or DC charging, turn
o󽗈 the charger before disconnecting
the charging connector. In Mode
2 charging, remove the charging
connector and then the power plug.
●
When charging is complete and the
charging connector is unplugged,
make sure that the charge port's cap
and door are closed, otherwise water
or foreign materials may enter the port
and a󽗈ect its normal use.
●
During DC charging, the DC charging
power is relatively small during the
identi󽗉cation period to identify the
real capability of the charging pile
and allow the charging pile to exert
its maximum output capacity, thereby
bringing a better charging experience
to users. (only for motor booster DC
Charge).
●
Before starting the vehicle, ensure
that the charging equipment is
disconnected. The locking mechanism
can damage the charging equipment
and the vehicle if the vehicle is
started with the charging connector
incorrectly inserted.
●
When the temperature is low, it is
recommended to charge the vehicle in
heated space indoors.
●
When the temperature is high,
charging in a cool, ventilated place is
recommended.
●
Battery temperatures that are too
low or too high compromise vehicle
charging performance.
●
The temperature control system can
improve low-temperature charging
capacity of the battery. Due to output
77
04
USING AND DRIVING