BYD Seal 2024 - Automatic Vehicle Hold (AVH)

Automatic Vehicle Hold
(AVH)
Automatic Vehicle Hold (AVH) The
automatic vehicle hold (AVH) is activated
automatically when the moving vehicle
needs to be stationary for longer periods
of time, such as in traffic jams on a slope
or waiting at traffic lights.
AVH standby
●
When the ignition is on, press the AVH
switch to enable AVH.
is displayed
on the instrument cluster.
●
Press the AVH switch again to disable
AVH.
AVH activated
●
When the AVH standby indicator
is
solid on, press the brake pedal until
the vehicle stops (vehicle speed goes
to zero) to avtivate AVH function. At
this time, the vehicle is in AVH state
with
displayed on the instrument
cluster.
CAUTION
●
For AVH to be activated, all of the
follow conditions must be met:
●
The driver's seat belt is fastened
and the doors are closed.
CAUTION
●
Intelligent power braking system
and electronic park brake (EPB)
systems are normal.
●
Pressing the accelerator pedal,
shifting into Park, powering off
the vehicle, or engaging the EPB
manually can make AVH exit to
the standby status.
●
AVH has a memory function,
which will keep the state of the
last power off when it is powered
on again.
AVH running
●
The AVH runs normally when it is
activated, brake lights and the high-
mount brake light are on, and the
AVH indicator
is solid on on the
instrument cluster.
●
The AVH function exits to the standby
mode after the vehicle stops for
10 minutes, with the AVH standby
indicator
lighting up and gear
shifted into Park.
●
To activate AVH funtion, shifting into
Drive to enable the vehicle to move,
and then press the brake pedal until
the vehicle stops (vehicle speed goes
to zero).
AVH exits
●
When the AVH funtion runs normally,
AVH exits and the the gear is shifted
into Park form Drive automatically
when the driver performs the
followings:
●
Open the driver's door.
●
Unlock the driver's seat belt.
●
The gear status is in Drive when the
vehicle stops, and EPB is enabled.
112