BYD Seal 2024 - Page 121

weather conditions, such as dense fog,
heavy rain and heavy snow, liable to
hinder the sensing operation of front
mmWave radars or the multi-purpose
camera.
●
Situations where ICC cannot be used
include:
●
The sensor is blocked.
●
The vehicle is running under severe
weather conditions.
●
Active safety function is triggered.
●
Vehicle speed exceeds specified
range.
●
ACC cannot be activated in special
driving modes like tow/snow/mud/
sand/terrain (if equipped with these
modes).
WARNING
●
ICC serves as a driver assistance
function only, so the driver must
be fully responsible for driving
safety.
●
Influence of weather, road
conditions, and other factors may
cause ICC to fail.
●
Use ICC based on your needs,
traffic, and road conditions.
Predictive Collision
Warning (PCW) &
Automatic Emergency
Braking (AEB)
Predictive collision warning (PCW) system
and Automatic Emergency Braking(AEB)
system detect vehicles and pedestrians
ahead by using a radar and a multi-
purpose camera. When detecting a risk
of collision, the system gives audible
and visual alarms to alert the driver and
improves the potential braking pressure
for better response timing. If detecting
increased risk of collision, the system
automatically applies braking pressure to
assist in collision avoidance or impact
reduction.
Usage
●
Enable or disable the PCW and AEB in
→ ADAS → Active Safety.
●
PCW gives alarms in forms of audio,
messages, and intermittent braking.
●
When PCW is activated,
or
flashes, depending on the level of
emergency, together with a prompt
message on the instrument cluster.
●
When AEB is triggered,
flashes
together with a prompt message on
the instrument cluster.
●
In the event of malfunction,
is
displayed on the instrument cluster.
●
If you disable AEB manually by
pressing buttons,
is displayed on
the instrument cluster.
PCW Activation Conditions
●
This function has been turned on in
Vehicle Settings.
●
Vehicle speed is within the 16 km/
h-150 km/h range.
●
The vehicle is in Drive.
●
The vehicle does not slide backwards.
AEB Activation Conditions
●
This function has been turned on in
Vehicle Settings.
●
Vehicle speed is within the 4 km/h-150
km/h range.
●
The EPB has been released.
●
The vehicle is in Drive.
●
The vehicle does not slide backwards.
120