●
When the blind spot assist system
is standing by, if vehicle conditions,
such as speed or gear status, do not
meet the requirements of any function,
is displayed on the instrument
cluster and blind spot assist will not be
activated.
●
If the blind spot assist system
malfunctions,
is displayed on the
instrument cluster.
●
When the blind spot assist system is
active,
is displayed, meaning that
the function has been activated and
can trigger alarms at any time.
Precautions
●
While the BSD system provides
assistance in monitoring blind spots
of rearview mirrors, it cannot replace
the driver's observation and judgment.
The driver must keep control of vehicle
at all times and drive properly and is
fully responsible for the vehicle.
●
The BSD system may be unable to
provide adequate warning on target
vehicles approaching from behind at a
high speed.
●
The driver must ensure the normal
operation of the BSD system, keeping
its rear corner mmWave radars in good
condition. For example, dirt, snow, or
other obstructions need to be cleared
right away.
●
The BSD system gives a warning if
unrelated targets at the rear side or in
the rear (such as work zone barriers,
large roadside billboards, reflectors
in tunnels, or other objects with a
large radar cross section) are wrongly
selected as target vehicles.
●
Detection may be affected or delayed
in some environments. If the radar
cross section of the target vehicle is
too small (a bicycle, electric moped or
pedestrian, for example), the system
may fail to identify targets, leading
to false alarms. In addition, detection
may also be affected or delayed by
noise or electromagnetic interference.
●
RCTB activation scenario:
●
A pedestrian is crossing behind the
vehicle when it is reversing at a low
speed.
System Limitations
●
The activation of the RCTB system
depends on various factors such as the
environment, the state of the vehicle
and the target. There is no guarantee
that the emergency braking can always
be activated in every scenario.
●
Under some circumstances, it is
difficult for the system to assist the
driver, and detection may be affected
or delayed. Possible circumstances
include, but are not limited to:
●
The vehicle coming from behind
changes the lane suddenly.
●
Vehicles coming from behind are
detected too late at sharp turns,
slopes, or other settings.
●
The target vehicle is obscured.
●
Vehicles come from behind at a
relative speed above 80 km/h.
●
The vehicle is on a curve which is
too sharp, or is entering or exiting a
curve.
●
The vehicle is running under severe
weather, such as rain or snow.
●
Rear corner mmWave radar(s) come
off, are loosely installed, or are
blocked.
●
The vehicle encounters certain metal
guardrails or similar road conditions.
132
To Next Page
Loading...
