vehicle stops. The function stops working
when the EPB is released.
ESC operation instructions
Intelligent power braking system has the
following new functions compared with
the original ESC system:
●
Brake assist mode
●
The brake assist mode is used
to adjust the brake pedal feel.
The relation curve between the
brake pedal depth and the vehicle
deceleration varies across different
modes for the driver to choose their
preferred pedal feel.
●
You can select Comfort or
Sport brake assist mode on the
infotainment touchscreen →
→
Vehicle → Intelligent Chassis.
●
Comfort Stop (CST)
●
Comfort stop: When the vehicle
decelerates to stop in a non-
emergency situation, intelligent
power braking system reduces the
stop-instant suspension pitch and
impact by controlling the brake
pressure of the four brakes, and
provides a smooth stop feeling.
●
Go to the infotainment touchscreen
→
→ Vehicle → Intelligent
Chassis to enable or disable comfort
parking.
●
After the function is triggered, the
braking distance may increase by 2-5
cm. Increase the distance from the
vehicle or obstacle ahead accordingly
before stopping your vehicle.
●
Brake disc wiping
●
Brake disc wiping function: When the
wiper switch is on or the rain sensor
detects rain, the intelligent power
braking system applies a small brake
pressure to all four brakes so that
pads come into contact with discs
to remove the water film from the
discs. This shortens brake response
time and braking distance.
●
As long as the system detects rain
or the wiper ON signal, the brake
discs are repeatedly wiped at certain
intervals to improve safety.
●
ESC working
●
If there is a risk of skidding or
backsliding when the vehicle starts
on a slope, or if either drive wheel is
spinning, the ESC indicator flashes to
indicate that ESC system is working.
●
Disabling ESC
●
If the vehicle gets stuck in snow or
mud, ESC may reduce power output
from the motor to the wheels. In this
case, you may need to turn off the
system to get out of the jam.
●
Turning off ESC
●
To turn off the ESC system, go to
infotainment touchscreen →
→
ADAS → Active Safety → ESC. ESC
also checks its operating status in
real time. If you turn off ESC while
it is working, it completes the active
intervention control rather than
executes the "shutdown" command
immediately. ESC is disabled only
after the intervention control is
complete.
●
After ESC is turned off, some ESC
functions may be re-enabled if you
press the ESC OFF switch again or the
vehicle speed exceeds the threshold
(80 km/h). In order to prevent ESC from
being turned on suddenly, ESC can be
activated again only when it is not in
a state of retaining vehicle dynamic
intervention.
●
Restarting ESC after the motor is
powered off
142
To Next Page
Loading...
