EasyManua.ls Logo

BYD Seal 2024 - Page 189

BYD Seal 2024
218 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Replace tires with excessive tread
wear.
Tire treads are cast with wear bars.
When the tread is even with the wear
bar, its thickness is less than 1.6 mm.
The adhesion of tires worn to this
extent is very small on wet roads.
Tires with exposed wear bars are
experiencing serious performance loss
and therefore must be replaced.
Maintenance
In addition to proper inflation, proper
wheel alignment also helps reduce
tread wear.
If uneven tire wear is found, go
to a BYD authorized dealer or
service provider and check the wheel
alignment.
The vehicle has been balanced in
the factory, but tires need to be re-
balanced after driving for a period of
time.
If there is some kind of continuous
vibration while driving at high speeds
(above 80 km/h), but not at low
speeds, go to a BYD authorized dealer
or service provider and check the tires.
If a tire has been repaired, be sure to
re-balance it.
When installing a new tire or replacing
a new wheel, always perform tire
balancing.
CAUTION
Improper wheel balancers will get
stuck, become loose and fall off.
While driving, this will damage the
car or surrounding objects.
Improper wheel balancers will
damage the aluminum rims of
the vehicle. Therefore, it is
recommended to use original
wheel balancers.
Tire Rotation
In order to make tires wear the same
and prolong their service life, it is
recommended to check the wheel
tread wear inside and outside every
10,000 km and rotate tires and conduct
four-wheel alignment if necessary.
Do not rotate tires when a spare tire is
used for the vehicle.
After tire replacement, contact a BYD
authorized dealer or service provider
for tire pressure matching.
Directional tires and wheels
When purchasing replacement tires,
you may find that some tires are
"directional", which can only be
rotated in one direction. If directional
tires are used, only the front and rear
wheels can be swapped in tire rotation.
Tire rotation is as shown:
1. ① Non-directional tires and wheels.
2. ② Directional tires and wheels.
188

Table of Contents

Related product manuals