contact a BYD authorized dealer or
service provider.
●
If the tire pressure reaches between
180 and 320 kPa (green and yellow
areas shown in the figure), remove
the kit as soon as possible and drive
at a speed below 80 km/h within
one minute, with the furthest driving
distance not exceeding 10 km, so that
the tire sealant is evenly distributed
within the tire.
●
Observe the tire pressure gauge
reading on the inflator.
●
If the tire pressure is greater than
220 kPa, drive to the nearest service
center at a speed below 80 km/h.
●
If the tire pressure is between 130
and 220 kPa, repeat the process
to fill the tire sealant into the tire
and observe the tire pressure gauge
reading on the inflator.
●
If the tire pressure does not reach 130
kPa, it is recommended to contact
a BYD authorized dealer or service
provider.
REMINDER
●
Using tire repair kit on damaged
tires is only an emergency
solution. Please change the tires
at a professional repair center
as soon as possible. It is
recommended that you contact
a BYD authorized dealer or
service provider and inform the
maintenance technician that tire
sealant has been used.
●
After repairing a tire with the tire
repair device, it is recommended
that you purchase new tire
sealant and inflation hoses at a
BYD authorized dealer or service
provider.
●
Avoid hard acceleration and high-
speed turns.
●
Do not exceed the 80 km/h
maximum speed limit and replace
flat tires as soon as possible. Do
not drive further if the vehicle
experiences strong vibration,
unstable performance, or noise.
●
When the tire sealant is about
to expire (see the label on the
canister for exact date), replace it
with a new one.
If the Low-Voltage Battery
Is Exhausted
When the vehicle cannot start due to
under voltage of low voltage distribution
box, try to start it as per the following
steps:
1. Open the Hood.
2. Remove the left trim panel of front
compartment.
3. Connect one end of the red positive (+)
cable to the positive (+) terminal of the
198
To Next Page
Loading...
