1. Pull up the folding release clasp on the
seatback to fold the rear seatback.
2. There is an emergency unlocking
mechanism on the lid cover, open the
lid cover in the vehicle by pulling the
emergency opening lever on the left (as
shown in the figure).
REMINDER
●
When the entire vehicle is
powered off, the trunk can be
unlocked from inside the vehicle.
Setting trunk opening height*
●
Open the trunk manually or
automatically to the desired position,
keep it at this position, and then press
and hold the interior trunk button
for over three seconds. The speaker
sounds for one second, indicating that
the opening height is set to the current
position.
●
Set the trunk opening height by going
to the infotainment touchscreen →
→ Settings → Window and Lock.
Anti-pinch function
If the trunk receives a hindering force
while it is closing, it will automatically
switch to the opposite direction. If it
receives a hindering force while it is
opening, it will halt.
When the trunk fails to act
automatically
Close the trunk manually for recovery.
Reconnecting the low-voltage battery
Close the trunk manually to ensure the
power trunk lid functions normally.
WARNING
●
In order to prevent serious injury
or death, make sure to observe
the following precautions when
you operate the trunk lid:
●
Never activate the anti-pinch
function with your body.
●
If there are people nearby,
inform them that the lid is about
to open or close for safety.
●
Make sure hands and fingers are
clear from the lid area when
closing it.
●
When opening or closing
the trunk, make sure the
surrounding area is safe.
●
Make sure the trunk is closed
when driving.
●
Remove any load like ice
or snow from the lid before
opening the trunk, otherwise
the lid may close again.
55
03
CONTROLLER OPERATION
To Next Page
Loading...
