WARNING
●
Stop discharging immediately if
there are any abnormalities such
as peculiar smell and smoke.
●
See
P80
for discharging safety
warnings.
●
Store the product in a cool and
dry place when it is not in use.
●
When discharging, do not place
the equipment in the trunk, under
the front of the vehicle, or near
the tires to prevent it from falling
and being rolled over by the
vehicle and trampled on.
●
Never use the equipment if the
power strip cable becomes soft, if
the discharging connector cable is
worn out, if the insulation layer is
cracked, or if any other damage
occurs.
●
Never use the equipment when
the discharging connector or
power strip is disconnected or
broken, or when there is any sign
of surface damage.
CAUTION
●
Avoiding damage to
the discharging equipment
(precautions for discharging
equipment):
●
Prevent the discharging
equipment from suffering any
mechanical impact such as
dropping or hitting.
●
Do not place the discharging
equipment near heaters or other
heat sources.
●
Before discharging, please
confirm the vehicle SOC and
CAUTION
estimate the remaining driving
range.
●
Before VTOL discharging, ensure
that the load is turned off.
REMINDER
●
Try to use this function when the
SOC is high.
●
The VTOL function is restricted
when the vehicle SOC is low.
●
The static power consumption
of the vehicle will increase if,
when the vehicle is powered
off, the VTOL connection
device is connected for an
extended period without any
output. Therefore, removing the
discharging/charging connector
when the device is not used is
recommended.
External Discharging Method
Discharging
●
Before discharging, turn off the anti-
theft mode of the vehicle.
●
Unlock the charge port door, then
open the port door and cap.
●
Check before discharging:
1. Ensure that the battery capacity of
the vehicle to be discharged is not
below 15%.
2. Ensure the VTOL connecting device
casing is not cracked, and its plug is
free from rust or obstructions.
3. Ensure that there is no water or
foreign material inside the charge
port and that metal terminals are
not damaged and free from rust or
corrosion.
91
04
USING AND DRIVING
To Next Page
Loading...
