BYD Seal 2024 - Charge Port Anti-Theft Lock

●
Do not discharge if any of the above
conditions is found; otherwise, short
circuit or electric shock so caused
could lead to personal injury.
●
Connect the discharge connection
device:
●
Connect the VTOL discharging
connector to the charge port and
confirm that it is connected in place.
●
After the switch button* on the
discharging socket is pressed, the
socket indicator stays on (red),
indicating that the socket can be used.
●
Discharging starts:
●
After the connection is made,
discharge begins and respective
information is displayed on the
instrument cluster.
Stopping discharging
●
Stop discharging:
●
Disconnect the load.
●
Disconnect the discharge connection
device:
●
With the vehicle unlocked, pull the
discharging connector out of the
charge port.
●
Close the charge port cap and the
port door (see
P84 ).
●
Organizing the equipment:
●
Store the equipment properly when
discharging is complete.
Charge Port Anti-theft
Lock
●
In order to prevent the charging
connector from being stolen, the
vehicle charge port is anti-theft during
charging and discharging. The anti-
theft function is deactivated by default.
To enable the function, go to the
infotainment touchscreen →
→
New Energy → Charging Settings and
then tap Activate.
●
Tap "Activate" or "Deactivate" in
Charging port anti-theft lock.
●
When the mode of charging port anti-
theft lock is activated, the charging
connector will lock if the user connects
the charging connector and the four
doors, hood and trunk lid are locked.
To disconnect the connector, the user
needs to unlock the vehicle.
Unlocking
●
When the function is enabled, unlock
the vehicle and unplug the charging
connector during charging in the
following ways:
●
When it is on OFF status, press the
unlock button on the smart key to
unlock.
●
Press the microswitch next to the
exterior handle of the driver's side
door to unlock.
●
Press the central unlock button on
the driver's side door to unlock.
92