EasyManua.ls Logo

BYD Seal 2024 - Low-Voltage Battery

BYD Seal 2024
218 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CAUTION
Prolonged exposure to heat
sources and direct sunlight
will reduce high-voltage battery
service life.
When the vehicle is not to
be operated for an extended
period (over seven days), it is
recommended that the battery
SOC should be kept at 40%-60%
to prolong its service life. When
the vehicle is not to be operated
for over three months, the high-
voltage battery must be fully
charged and then discharged to
40%-60% every three months.
Otherwise, over-discharge may
lead to battery performance
degradation or even damage. Any
vehicle fault or damage so caused
will not be warranted.
As the high-voltage battery is
arranged at the bottom of
the vehicle, careful driving is
recommended in case of bumpy
roads. If there is a collision
with the high-voltage battery,
contact a BYD authorized dealer
or service provider immediately
for maintenance.
No one is allowed to enter the
vehicle when the battery pack
needs to be repaired.
High-Voltage Battery Recycling
How to scrap an NEV:
1. Take the vehicle to the BYD recycling
service provider that will assess the
residual value of the high-voltage
battery.
2. Take the assessed vehicle to the
recycling organization to disassemble
the high-voltage battery.
3. Take the battery to the recycling
service provider which will buy back
the battery.
WARNING
New energy car owners have
the responsibility and obligation
to hand over waste high-voltage
batteries to the recycling service
outlet. Anyone who hands over a
used high-voltage battery to any
other organization or individual,
or removes/disassembles a
high-voltage battery without
authorization, shall be liable for
any environmental pollution or
safety incident so caused.
Low-Voltage Battery
The low-voltage battery (12V battery) is
located under the rear left seat.
Battery working modes include
"Normal", "Sleep", "Ultra-low Power",
"Low-Voltage Protection", etc. The
purpose is to protect the battery cell
from damage. If the vehicle system is
in good condition, the vehicle switches
between these modes automatically,
having no effect on your use of the
vehicle.
To avoid low-voltage battery feed,
the smart charging function will be
actively triggered if conditions (hood
closed, ignition "OFF", high-voltage
battery discharging allowed, and low-
voltage battery level lower than the
design value) are met.
When the intelligent charging function
is triggered, the low-voltage battery
is charged through the high-voltage
battery. Therefore, it is normal that the
SOC or the pure-electric driving range
displayed on the instrument cluster
decreases, when the vehicle is started
after being idle.
97
04
USING AND DRIVING

Table of Contents

Related product manuals