EasyManua.ls Logo

BYD SEAL U DM-i - Page 107

BYD SEAL U DM-i
260 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Mode Memory Function
1. In the case of high SOC, the vehicle
is automatically switched to EV mode
when it is powered on. Driving in this
mode is highly recommended.
2. In the case of moderate SOC, the
vehicle memorizes the last driving
mode when it is powered on. The
driver can manually select the required
mode through the mode switch now.
Power Generation by Pressing the
Accelerator Pedal
With the vehicle in P gear and HEV
mode, when SOC is lower than a
certain value, press the accelerator
pedal to trigger the power generation
function.
Discharging Instructions
The vehicle supports the Vehicle To
Load (VTOL) function.
WARNING
Do not touch the metal terminals
of the discharging strip and
the vehicle charging port during
discharging.
Stop the discharging device in
case of abnormality such as odour
and smoke during discharging.
For discharge safety warnings, see
Charging Safety Warnings.
Store the product in a cool and
dry place when it is not in use.
To prevent the charging
equipment from being rolled over
by the vehicle, falling, and being
trampled during discharging, do
not place the equipment under
the boot and the vehicle's front
end or near the tyres.
WARNING
Never drop the equipment or
move it by pulling it directly by
the cable.
Do not use the discharging
equipment when the discharging
device, cable, or power strip
is worn, the insulation layer is
broken, or there is any other
damage.
REMINDER
Try to use this function when the
SOC is high.
The static power consumption
of the vehicle will increase
when the vehicle is powered o󽗈
and the VTOL connection device
is connected for an extended
period without any output. It
is recommended to remove the
discharging/charging connector
when the device is not used.
CAUTION
Disconnect the discharging
equipment refers to Charging
Precautions.
Before V2L discharging, ensure
that the load is turned o󽗈.
During VTOL, the engine is started
when the battery level is low.
Please do not use the VTOL
function in a con󽗉ned space
or any other place adjacent to
󽗊ammables and explosives.
When VTOL discharges externally,
it will turn o󽗈 when the allowable
discharge power is exceeded.
At this time, please reduce
the power of the equipment,
106

Table of Contents

Related product manuals