BYD SEAL U DM-i - Page 108

CAUTION
and plug/unplug the discharging
equipment again.
VTOL Method*
1. Equipment Description:
●
Vehicle to Load (VTOL)： It consists
of a discharger, socket, cable, and
discharger protection cover.
2. Discharging Instructions
●
Before discharging, disarm the anti-
theft alarm system.
●
Unlock the charge port door, then
open the port door and cap.
●
For the speci󽗉c operation, refer
to the relevant procedures for
"Household Portable AC Charging".
●
Check before discharging:
●
Make sure that the VTOL adapter is
free of any abnormalities such as
shell rupture, cable wear, and plug
rust.
●
Ensure that there is no water or
foreign material inside the charge
port and that metal terminals are
not damaged and free from rust or
corrosion. Do not discharge if any
of the above conditions is found;
otherwise, short circuit or electric
shock so caused could lead to
personal injury.
●
Connect the discharge connection
device:
●
Connect the VTOL discharger into the
charging port reliably.
●
Discharging starts:
●
Press the switch on the discharging
outlet and wait for a few seconds.
If the outlet indicator (red) stays on,
the outlet can be used.
●
After the connection is made,
discharge begins and respective
information is displayed on the
instrument cluster.
3. Discharging Duration Setting
Instructions
●
After the vehicle is connected to
the discharger, the VTOL function is
automatically activated. At the same
time, the countdown can be observed
on the instrument cluster and the
infotainment touchscreen. The default
duration of single discharging on the
infotainment touchscreen is 5 hours.
●
To set VTOL, go to
(infotainment
system) → New Energy → Discharging
Settings.
●
After the vehicle is connected to the
discharger, tap the Vehicle To Load
button to turn it on or o󽗈 as needed.
107
04
USING AND DRIVING