EasyManua.ls Logo

BYD SEAL U DM-i - Page 111

BYD SEAL U DM-i
260 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WARNING
Non-professionals are not allowed
to open the power battery pack.
Units or individuals will bear
corresponding responsibilities for
environmental pollution or safety
accidents caused by unauthorized
removal and disassembly of
batteries.
High-Voltage Battery Recycling
How to scrap an NEV:
1. Take the vehicle to the BYD recycling
service provider that will assess the
residual value of the high-voltage
battery.
2.
Take the assessed vehicle to the
recycling organisation to disassemble
the high-voltage battery.
3. Take the battery to the recycling
service provider which will buy back
the battery.
WARNING
New energy car owners have
the responsibility and obligation
to hand over waste high-voltage
batteries to the recycling service
outlet. Anyone who hands over a
used high-voltage battery to any
other organisation or individual,
or removes/disassembles a
high-voltage battery without
authorisation, shall be liable for
any environmental pollution or
safety incident so caused.
Low-voltage Battery (12V)
The low-voltage battery used in this
vehicle is a BYD self-developed lithium
iron phosphate battery, referred to
as the 12V battery. The 12V battery
features a smart charging function.
When the high-voltage battery SOC is
su󽗋cient, the vehicle can enable the
high-voltage battery to charge the 12V
battery, so as to extend the endurance
of the 12V battery.
① Positive pole
② Negative pole
REMINDER
When the vehicle is powered o󽗈
for smart charging, it makes such
a normal sound as when the
vehicle is powered on.
Make sure that all electrical
equipment is turned o󽗈 and the
doors are closed when leaving the
vehicle.
Waking up the Vehicle from Low SOC
Wakeup by the front right door
microswitch:
The 12V battery features the dormant/
wakeup function. After long-term
parking, if the vehicle locating and
unlocking cannot be realized with the
smart key, the 12V battery may be
in a dormant state. Then, press the
microswitch on the front right door
handle to wake up the 12V battery.
After the vehicle is unlocked, it can be
used normally.
110

Table of Contents

Related product manuals