EasyManua.ls Logo

BYD SEAL U DM-i - Page 112

BYD SEAL U DM-i
260 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Wakeup by Jump Start:
When the vehicle cannot be waked
up and unlocked by the front right
door microswitch, use the mechanical
key to open the door. Then, a 12V
power supply can be used to start the
vehicle through two special cables for
the jump start. In this case, the 12V
battery SOC is low and the vehicle
may become dormant again. Start
the vehicle immediately and keep it
started for more than 15 min to ensure
that the 12V battery is fully charged.
The jump start can only be carried
out through the special interface of
the front compartment fuse box. The
connection terminals for the jump start
are shown in the right 󽗉gure.
① Positive terminal for the jump start in
the front compartment fuse box
② Negative terminal for the jump start
If the vehicle cannot be woken up and
started by the above operations, please
contact a BYD authorized dealer or
service provider immediately.
CAUTION
It is recommended that the
jump starting be done under the
guidance of professionals, as the
space for operating the under-
bonnet PDB is limited and circuit-
based risks are present.
WARNING
It is strictly prohibited to connect
the vehicle with other vehicles for
a jump start when its OK indicator
is o󽗈; otherwise, the 12V battery
may be damaged.
When it is necessary to use a
jump start for starting in case of
low 12V battery SOC or failure of
normal use, please read this part
of the Owner's Manual carefully
and strictly follow the relevant
instructions.
The 12V battery contains an
intelligent control module. Do
not disassemble or damage the
battery without permission in
non-emergency situations.
Please disconnect the negative
terminal of the 12V battery before
replacing the parts and repairing
and checking the vehicle.
Do not clean the 12V battery with
liquid to avoid ingress of liquid
into the battery.
Intelligent Charging
Low 12V battery SOC triggers the smart
charging function to extend the battery
endurance.
In case of low high-voltage battery
SOC, the vehicle may start the engine
for power generation to enable the
smart charging function.
111
04
USING AND DRIVING

Table of Contents

Related product manuals