BYD SEAL U DM-i - Page 128

the message "No key detected" is
displayed on the instrument cluster.
This means that the key is not in the
vehicle or cannot be detected due to
interference.
●
Even if the electronic intelligent key
is inside the vehicle, the vehicle may
not be started either when the key is
on the 󽗊oor, in the cup holder, in the
boot, or in the right glovebox.
●
If the quiescent duration of electronic
intelligent key is over 2 min, the vehicle
can not be started.
Starting the vehicle in emergencies:
●
Engage the parking brake 󽗉rmly.
●
Turn o󽗈 all lights and accessories.
●
Shift to "P" or "N”.
●
The power mode is "OFF".
●
The electronic smart key is in the
vehicle.
●
Press and hold the START/STOP button
for more than 15s to start the vehicle.
REMINDER
●
Do not touch the power button
while driving.
Driving
●
During the driving, energy is recovered
through regenerative brakes when
the vehicle decelerates. For higher
e󽗋ciency, do not accelerate or
decelerate the vehicle unnecessarily.
●
Users can go to the relevant setting
page via the touchscreen to select the
corresponding energy feedback mode
according to their driving habits.
●
Standard: When the accelerator
pedal is released, the motor
controller recovers energy in the
standard level, and the vehicle
deceleration is in the standard level.
●
High: When the accelerator pedal
is released, the motor controller
recovers more energy, and the
vehicle deceleration is high.
●
Users can choose the energy
feedback intensity according to their
needs when releasing the accelerator
to experience di󽗈erent senses of
deceleration, and obtain di󽗈erent
driving pleasures.
●
The set accelerator release energy
feedback intensity can be memorized.
Even after the vehicle is powered o󽗈,
the mode set last time remains valid
when the vehicle is powered on next
time.
REMINDER
●
Do not set the regeneration
intensity when driving the vehicle
in high speed, as the driver may
be distracted. This may distract
the driver and lead to accidents.
●
In HEV mode, the engine automatically
starts and stops as needed to charge
the battery or provide additional
power. In some conditions, the engine
may start, or stop if it has started.
●
The power of the whole vehicle is
weaker at low battery level than that
at high battery level.
Kick-Down function
During driving, when the vehicle is going
uphill or it is necessary to accelerate
rapidly or press the accelerator deeply,
almost fully pressing the accelerator
increases the pedal resistance and
triggers this function, so that the engine
speed increases to provide greater power
for the vehicle.
127
04
USING AND DRIVING