BYD SEAL U DM-i - Page 134

CAUTION
●
To exit the activated AVH and set
it to the standby mode, press the
accelerator pedal or shift to P. If
the AVH standby state are not met,
it will be o󽗈.
AVH Standby Preconditions (All Must Be
Met)
With the AVH function activated:
●
Driver seat belt has been fastened.
●
The driver's door has been closed.
●
The vehicle has been started.
●
The ESC system has no fault.
CAUTION
●
The AVH defaults to o󽗈 once
the vehicle is powered up. When
AVH is in standby mode,
is displayed on the instrument
cluster.
AVH Running Conditions (All Must Be
Met)
●
The AVH function is standby.
●
The vehicle is stopped by the control of
the brake pedal.
●
After hard depressing of the brake
pedal, the AVH function has been
activated and the AVH indicator has
turned green.
●
After the AVH function operates for
10 min, it automatically requests to
engage the EPB and the AVH returns to
the standby condition.
CAUTION
●
For AVH to be activated, all
conditions of automatic parking
function must be met.
●
Under the condition of AVH
activation and standy,when the
gear is shifted to “R”,the system
automatically enters the slow-
moving condition;when the gear
is shifted from "R" to "D" or "N",
the system maintains the slow-
moving condition, in which AVH is
deactivated. When the AVH button
is pressed or the speed exceeds
10 km/h, it exits the slow-moving
condition.
Key Points for Driving
Driving Instructions
●
Slow down when driving against
strong winds.
●
Drive slowly and carefully along gravel
roads and try to keep the correct angle.
To prevent tyre damage, do not drive
over sharp-edged obstacles. Or it will
severely damage the tyres.
●
Slow down on bumpy or uneven roads.
Otherwise, the impact may seriously
damage the wheel.
●
Washing the vehicle or driving through
deep water may wet the brake. Gently
press the brake pedal for check
after con󽗉rming that the surrounding
environment is safe. If the braking
force is not normal, the brake may
be wet. Drive carefully and press the
brake pedal gently while pulling up the
EPB button.
●
During driving, if the "START/STOP"
button is pressed for more than 3s,
the power output of the vehicle is
cut o󽗈 to realize emergency power-o󽗈.
133
04
USING AND DRIVING