BYD SEAL U DM-i - Traffic Sign Recognition System

the function has been activated and can
trigger alarms at any time.
System Limitations
●
Under some circumstances, it is
di󽗋cult for the system to assist the
driver, and detection may be a󽗈ected
or delayed. Possible circumstances
include, but are not limited to:
●
The vehicle coming from behind
changes the lane suddenly.
●
Vehicles coming from behind are
detected too late at sharp turns,
slopes, or other settings.
●
The target vehicle is obscured.
●
Vehicles come from behind at
a relative speed above 80km/h
(50mph).
●
The vehicle is on a curve which is
too sharp, or is entering or exiting a
curve.
●
The vehicle is running under severe
weather, such as rain or snow.
●
Rear corner mmWave radar(s) come
o󽗈, are loosely installed, or are
blocked.
●
The vehicle encounters certain metal
guardrails or similar road conditions.
●
Targets that may not be responded
include, but are not limited to,
pedestrians and animals.
●
The environment contains
electromagnetic interference or
other in󽗊uences.
●
The calibration of rear corner mmWave
radars may be a󽗈ected by vibration
or collision, resulting in compromised
BSA performance. If this is detected,
contact a BYD authorised dealer or
service provider.
Precautions
While the BSA system provides assistance
in monitoring blind spots of rearview
mirrors, it cannot replace the driver's
observation and judgment. The driver
must keep control of vehicle at all times
and drive properly and is fully responsible
for the vehicle.
BSD may fail to adequately exert the
warning function when the target vehicle
is approaching from behind very fast.
The driver shall ensure that BSA can
operate normally, keep the environment
of rear corner mmWave radars in
good condition, and timely clear any
obstructions such as dirt or snow.
BSD activates an alarm when irrelevant
targets at the rear sides of or behind the
vehicle (e.g., large roadside repair signs,
large roadside billboards, re󽗊ectors in
tunnels and other objects with high radar
cross sections) are mistakenly detected as
target vehicles.
WARNING
●
Blind spot assist serves as a
driver assistance function only, so
the driver is fully responsible for
driving safety.
●
BSA may fail due to factors such
as unfavorable weather and road
conditions.
●
Use BSA based on your needs
along with tra󽗋c and road
conditions.
Tra󽗋c Sign Recognition
System*
The tra󽗋c sign recognition (TSR) system
recognizes speed limit signs through
the multi-purpose camera and map*. It
displays relevant speed limit signs of the
current road on the instrument cluster
152