BYD SEAL U DM-i - Page 163

view interface, there
is no change.
which can get the
same result.
WARNING
●
The panoramic view system
provides transparent panoramic
view to show the image below the
vehicle. This function is only for
assisting in observation of area
below the vehicle during parking/
driving. Investigation of foreign
objects below the vehicle and
dangerous situations should be
carried out in any other manner
to ensure the safety of personnel
and the vehicle.
●
When the vehicle runs at a low
speed, the transparent panoramic
view function is a󽗈ected by speed
󽗊uctuation or multiple stops,
so there will be misalignment
between the images below the
vehicle and that outside the
vehicle.
●
This system uses wide-angle
󽗉sheye cameras, so the object
on the display screen may
appear somewhat deformed in
comparison with the actual
object.
●
The panoramic view system is
only to be used for parking/
driving assistance. It is not safe
to rely solely on this system to
park or drive the vehicle, because
there are some blind spots in
front of and behind the vehicle.
The surroundings of the vehicle
should be observed in other
ways during the parking/driving
process, so as to avoid accidents.
●
When the side mirrors are not
extended in place, do not use
the panoramic view system; and
WARNING
when the panoramic view system
is used for parking/driving, ensure
that all the car doors are closed.
●
The distance to an object
displayed on the panoramic view
screen may be di󽗈erent from the
distance perceived subjectively,
especially when the object is
closer to the vehicle. Assess the
distance in various ways.
●
Cameras are installed above the
front grille, side mirrors, and the
rear number plate. Make sure the
cameras are unobstructed.
●
To prevent a󽗈ecting camera
performance, avoid spraying
directly on the cameras when
washing the vehicle body with
high-pressure water. Wipe any
water or dust o󽗈 the camera in
time.
●
Protect the cameras from any
impact to prevent damage or
malfunction.
●
After the vehicle is powered on,
if you press the panoramic view
start button or shift into reverse
while the infotainment system is
not fully activated, the output on
the panoramic view screen will
be delayed or the screen will
󽗊ash. This is a normal part of the
camera power-on process.
●
After the vehicle starts, the image
before last power-o󽗈 is displayed
on the transparent panoramic
view screen. Foreign bodies
shown may be inconsistent with
the actual ones in the underbody
162