BYD SEAL U DM-i - Tyre Pressure Monitoring

Tyre Pressure Monitoring
●
The direct tyre pressure monitoring
system is an auxiliary system that
monitors tyre pressure in real time to
improve vehicle safety and comfort
and reduce tyre wear and energy
consumption due to insu󽗋cient tyre
pressure.
●
The user can access the instrument
cluster menu by pressing the
button on the steering wheel, navigate
to the driving information bar by
pressing the and buttons, and
then select the tyre pressure display
interface using the roller on the button.
System Function
1. Power-on alarm
The tyre is already in a low pressure state
when the vehicle is powered o󽗈. When
the vehicle is powered on again, a low
pressure alarm is given immediately to
prompt the user to in󽗊ate the tyre before
driving.
2. Low tyre pressure alarm
●
When the pressure of any one of
the four tyres is lower than 85% of
the standard tyre pressure and the
system is running, the tyre pressure
fault indicator lights up and the tyre
pressure value turns yellow. It is
advisable to stop the vehicle and check
the corresponding tyres for slow leaks
and to in󽗊ate them to a reasonable
pressure.
●
When the tyre pressure is greater than
90% of the standard value, the low
pressure alarm is canceled.
3. Fast air leakage alarm
When one or more tyres leak at a rate
above or equal to 30 Pa/min and the
system is running, the tyre pressure fault
indicator keeps 󽗊ashing and the tyre
pressure value becomes red. If the vehicle
has started to give an air leak alarm,
please stop the vehicle in time to check
the faulty tyres.
4. Fault alarm
If there is a fault when the system
is running, the tyre pressure fault
indicator 󽗊ashes and then keeps on,
and the instrument cluster displays
"Abnormal Signal". Check the tyre
pressure monitoring module, and for
any surrounding electromagnetic source
nearby.
5. Real-time tyre pressure display
Tire Pressure Monitor System (TPMS)can
display the information on each tyre
pressure in real time when it is running.
Precautions
●
The running time of the tyre pressure
monitoring module is related to the
daily travel distance and other factors.
●
The monitoring module regularly
transmits tyre pressure and other
information to the display. Therefore,
if the tyre pressure drops suddenly
or there is a 󽗊at tyre, the monitoring
module will not transmit data to
the display until the next monitoring.
In this case, the vehicle may be
out of control. If a damaged tyre
is accompanied by the monitoring
module damage and thus no message
can be sent, or if it is suspected that
a tyre has been damaged, stop driving
immediately, instead of waiting for the
display to send an alarm signal.
●
Incorrectly installed monitoring
module a󽗈ects the air tightness of
the tyre. It is recommended that
the installation and replacement of
the pressure monitoring module be
carried out by professional technicians
of a BYD authorised dealer or
167
04
USING AND DRIVING