BYD SEAL U DM-i - Head-Up Display (Hud)

service provider in accordance with
the requirements of the installation
manual.
●
To change tyre position or replace
tyre pressure monitoring module, 󽗉rst
rematch the entire tyre monitoring
system. It is recommended to have this
done by the professional technicians
from a BYD authorised dealer or
service provider; otherwise, system
failure may occur.
●
Since tyre pressure varies with regional
temperatures, in󽗊ate or de󽗊ate the
tyres according to the values displayed
on the instrument cluster and the
standard tyre pressure values.
●
TPMS applies wireless transmission,
which may lead to poor reception
under serious interference.
CAUTION
●
The system does not stop
vehicle travelling in the event
of abnormal tyre pressure.
Therefore, each time before
driving, start the vehicle statically
to check whether the tyre
pressure meets the requirements
speci󽗉ed by the manufacturer.
If not, do not drive, otherwise
vehicle damage or personal injury
can occur.
●
If pressure is found to be
abnormal while driving, check
the tyre pressure immediately. If
the low pressure warning light
comes on, avoid sharp turns or
emergency braking, and reduce
vehicle speed, pull it over to
the kerb and stop as soon as
possible. Driving with low tyre
pressure can cause permanent
damage to tyres and increase
the likelihood of tyre scrapping.
Serious tyre damage can lead
CAUTION
to tra󽗋c accidents, resulting in
serious injuries or deaths.
Head-up Display (HUD)*
Head-up Display (HUD)*
HUD shows essential information (such
as vehicle speed, speed limit, ACC, lane
departure and BSD) that is projected
outside the front windscreen and
re󽗊ected to the driver's 󽗉eld of view. This
avoids frequent switching of eye focus
and improves driving safety 。
How to Use
To enable or disable HUD, go to
infotainment touchscreen
→
Vehicle Settings. By factory default, the
switch is toggled on and a HUD image is
displayed. When the switch is toggled o󽗈,
no HUD image is displayed. The system
defaults to the previous settings when the
vehicle restarts.
Set HUD
●
Height adjusting: 21 levels of
brightness adjustment (-10 to 10) for
HUD virtual images (default level: 0).
●
Brightness adjusting: 11 levels of
height adjustment (1 to 11) for HUD
virtual images (default level: 6).
168