EasyManua.ls Logo

BYD SEAL U DM-i - Page 187

BYD SEAL U DM-i
260 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WARNING
Do not touch the side mirrors
when the rear defroster is
activated, because their surfaces
will be hot.
CAUTION
When cleaning the inside of the
rear windscreen, take care not to
scratch or damage heating wires
or connectors.
Ventilator
Tap this button to activate A/C
ventilation control. The outlet air is
natural air.
Tap this button again to deactivate
A/C ventilation control and enter AUTO
mode.
Air distribution
Tap an icon on the infotainment
touchscreen to select the corresponding
air distribution mode. Blowing modes can
be freely selected on the infotainment
system screen, and up to three blowing
modes can be activated at the same time
as required.
: Air 󽗊ows to the face level.
: Air 󽗊ows to the foot level.
: Air 󽗊ows to the front windscreen and
side windows.
Precautions for Operation
To quickly cool down the vehicle
parked under the burning sun, open
the window and drive for several
minutes. to exhaust hot air and speed
up A/C cooling.
To cool down quickly, adjust the
temperature to "LO" and keep the
setting in recirculation mode for
several minutes.
Make sure that the air inlet grille in
front of the front windscreen is not
blocked (by such things as leaves or
snow).
In wet weather, do not let cold air blow
onto the windscreen. The temperature
di󽗈erence between the inside and
outside of the windscreen causes
fogging windscreen.
Keep the space under the front seats
clear to improve air circulation.
In cold weather, the fan speed is
recommended to be set to a high
speed for one minute to remove snow
or moisture from the intake channel,
so as to reduce fogging of the window.
In cold weather, enable recirculation
mode for a few minutes for quick
heating. and switch to fresh air mode
to prevent fogging after cabin is heated
up.
186

Table of Contents

Related product manuals