BYD SEAL U DM-i - Page 196

REMINDER
smartphone back to the wireless
charging area.
●
If the phone cannot be charged
properly, ensure that there are
no foreign objects in the wireless
charger area, or wait for the
wireless charger area to cool
down before trying again. If it
is still impossible to charge the
phone, contact a BYD authorised
dealer or service provider.
CAUTION
●
Ensure your smart key is more
than 10 in (25 cm) away from
the wireless charger area when
the wireless charger system is
working.
●
To avoid wireless charger
dysfunction or even accidents, do
not place coins, metal keys, metal
rings, or other articles containing
metal in the wireless charger area
together with the phone.
●
Do not place heavy objects on
the charging area to avoid any
damage.
●
If the phone wireless charger
system is faulty and does not work
properly, it is recommended to
contact a BYD authorised dealer
or service provider.
●
BYD will not assume any
responsibility for any problems
caused by improper use. If
the product is disassembled or
modi󽗉ed, the free warranty will be
terminated.
●
For safety reasons, do not leave an
unattended phone being charged
in the vehicle.
CAUTION
●
For safety reasons, refrain from
checking phone charging status
while driving.
●
If a metal item is found between
the device and the charger rubber
pad during charging, do not
remove the metal item with bare
hands to prevent burning.
●
For better charging, place the
smartphone in the centre (where
the "Charging Area" is shown).
●
Prevent any 󽗊uid from coming
into contact with the charger
area. The wireless charger will
malfunction if water enters the
wireless charger via the gap
around the rubber mat.
●
Charging may stop at high
temperatures, and will resume
once the temperature drops.
●
BYD makes no commitments for
problems caused by external
wireless charging coils. Please use
with caution.
Boot Cover Board
The boot cover board can be installed at
two di󽗈erent heights. Press the handle on
the cover board to remove it and adjust
height.
1. When installed at the upper height
position, the boot cover board is 󽗊ush
with the top surface of the support
plate. When the rear seats are laid
down, the boot cover board is 󽗊atly
󽗉tted with the back of the seats.
195
05
IN-VEHICLE DEVICES