BYD SEAL U DM-i - Page 231

WARNING
●
When the engine is running, keep
hands and clothes at a certain
distance from the rotating fan and
engine pulley.
4. In case of coolant leakage, stop the
engine immediately and contact a BYD
authorized service provider for help.
5. If there is no obvious leakage,
check the expansion tank. If coolant
is insu󽗋cient, be sure to open
the expansion tank cover after the
engine coolant temperature drops to
the normal value.When the engine
is running, add coolant into the
expansion tank to the upper scale
mark. Cover the expansion tank cover
properly and start the engine for 2
to 3 cycles (start the fan without
turning on the A/C). After the engine
coolant temperature drops to the
normal value, check the level in the
expansion tank again. If necessary, add
more coolant to the appropriate scale.
A serious loss of coolant indicates
a leakage in the system. In this
case, contact a BYD authorized service
provider for inspection immediately.
WARNING
●
To avoid serious injury caused
by high-temperature steam and
liquid ejection, do not open the
auxiliary tank cover when the
engine and radiator are hot.
After parking, if the high-voltage battery
SOC is low, do not use the A/C for a
long time, because it consumes battery
SOC. Low battery SOC triggers the
engine to generate electricity, which may
cause an accident or 󽗉re due to engine
overheating.
If the Vehicle Needs
Towing
If the vehicle needs towing, it is
recommended to contact a BYD
authorised dealer or service provider,
a professional towing service, or the
organisation you joined for roadside
assistance.
WARNING
●
The vehicle must not be towed by
other vehicles using only ropes or
chains.
Common towing methods include:
●
Flatbed device
●
When the vehicle is faulty and needs
towing, a 󽗊atbed trailer is the best
choice. The front and rear wheels
must be o󽗈 the ground when the
vehicle is being towed, otherwise
high-voltage components will be
damaged.
Tow Eye
The position to fasten the front towing
hook is shown in the 󽗉gure.
1. Open the cover with a straight
screwdriver.
2. Install the tow eye in the tow eye
opening.
230