BYD SEAL U DM-i - Page 235

REMINDER
●
When plugging the power plug
into the backup power supply in
the vehicle, make sure that the
in󽗊ator pump is turned o󽗈.
●
The in󽗊ator can only be turned on
for up to 10 minutes.
●
The working current of the backup
power supply is less than 10A.
●
During use, the voltage and power
should not exceed the rated
voltage of 12V and rated power
of 120W marked on the backup
power supply, otherwise, there
are potential safety hazards.
WARNING
●
When starting the vehicle,
the vehicle should be located
outdoors or in a well-ventilated
place (such as a building).
Running the engine in a
nonventilated or poorly ventilated
place may cause su󽗈ocation.
●
Observe the tyre pressure reading on
the in󽗊ator.
●
If the tyre pressure does not
reach 200 kPa (2.0 bar) within 10
minutes (red area shown in the
󽗉gure), turn o󽗈 the in󽗊ator. You
are recommended to contact a BYD
authorized dealer or service provider.
●
If the tyre pressure reaches between
200 and 320 kPa (between 2.0 and 3.2
bar) (green and yellow areas shown in
the 󽗉gure), remove the kit as soon as
possible and drive at a speed below
80 km/h (50mph) within 1 minute,
with the furthest driving distance not
exceeding 10 km (6miles), so that
the tyre sealant is evenly distributed
within the tyre.
●
Stop to check the repaired tyre and the
tyre pressure reading on the in󽗊ator.
●
If the tyre pressure is greater than
250 kPa (2.5 bar), drive to the nearest
service centre at a speed below 80
km/h (50mph).
●
If the tyre pressure is between 200 to
250 kPa (2.0 to 2.5 bar), inject the tyre
sealant into the tyre and observe the
tyre pressure readings on the in󽗊ator.
●
If the tyre pressure does not reach
200 kPa (2.0 bar), contact a BYD
authorized dealer or service provider.
234