BYD SEAL U DM-i - Anti-Theft Alarm System

WARNING
do not touch any high-voltage
components (such as battery
assembly) or cables (in orange)
connecting components. If there
are uninsulated wires inside or
outside the vehicle, do not touch
them to avoid electric shock.
●
If the liquid leaks into some parts
of the vehicle, do not touch the
liquid, because it may be the
electrolyte of the 12V battery. If
the 󽗊uid contacts the skin or
eyes, 󽗊ush with plenty of water
(preferably boric acid solution)
and seek medical attention to
avoid severe injury.
●
If the vehicle catches 󽗉re, use a
special 󽗉re extinguisher to put out
the 󽗉re or wait for the arrival of
󽗉re󽗉ghters.
●
If the vehicle needs to be towed,
please tow it with all four wheels
o󽗈 the ground. If the wheels touch
the ground during towing, the
motor may continue to generate
electricity, resulting in electric
leakage.
Anti-theft Alarm
system
Anti-theft Alarm system
When armed, the system sounds an alarm
and triggers turn signal 󽗊ash when any
door is opened.
Arming the system
1.
Switch the ignition o󽗈.
2. All occupants get o󽗈 the vehicle.
3.
Lock all doors. This makes the
anti-theft indicator steady on. The
anti-theft alarm system will arm
automatically after 10 seconds. and
the anti-theft indicator will then begin
to 󽗊ash.
4. You can leave the vehicle after
con󽗉rming that the indicator begins to
󽗊ash. Since unlocking the door from
inside the vehicle will activate the
system, never let anyone stay in the
vehicle with the system enabled.
Triggering the alarm
●
The system will raise an alarm in any of
the following situations:
●
Any door, boot, or bonnet is opened
without using the keyless access
function of the smart key.
●
The vehicle is powered on without
using the smart key start function.
Disarming the system
●
Anti-theft alarm can be stopped by:
●
Unlocking the door with a valid smart
key.
●
Use of the microswitch to unlock the
vehicle.
●
the boot lid is opened remotely with
the smart key;
41
01
SAFETY