BYD SEAL U DM-i - Adjusting Front Seats

WARNING
are not fully locked can cause
personal injuries in an accident or
emergency braking.
●
Do not put the seatback down
while driving or riding in the
vehicle. This makes the shoulder
strap of the seat belt not properly
attached to the body. As a result,
you and your passengers could hit
the strap in an accident, causing
serious injury to the neck or other
parts; or you and your passenger
may slip out of the waist belt,
resulting in other serious injuries.
●
During driving, no one is allowed
to sit in the boot area or on
the folded seat. Using these
areas without proper protective
measures may cause serious
injuries in case of an accident or
sudden braking.
●
Do not adjust the seat while
the vehicle is in motion, as
unpredictable seat movement can
cause the loss of vehicle control at
this time.
●
Do not drive the vehicle until
occupants are seated properly.
●
Before laying the rear seats down,
check the positions of the rear
headrests and the front seats, to
avoid interference among the rear
seats, the front seats and central
passage.
REMINDER
●
When folding in the rear seats,
be careful not to damage the
seat belt, and check whether the
buckle is correctly placed in the
buckle slot on the seat cushion.
REMINDER
●
Do not fasten seat belts before
seat adjustment.
●
While adjusting a seat, do not let
it hit against any passenger or the
luggage.
●
During the measurement of seat
cushion depth, the front and rear
positions of the seat are the
rearmost positions of the slide
rail, and the design angle of the
backrest is 25°.
●
During the measurement of seat
cushion width, adjust the backrest
angle to the designed state (the
backrest angle of the second
row seats is 28°), and adjust the
seat slide rail* to the rearmost
position. For the separable and
combinable seats in the same row,
measure the cushion width as a
whole row of seats.
Adjusting Front Seats
Adjusting Front Seat with Power*
Electrical front seats adjustment includes
back-and-forth adjustment of seat, up-
and-down adjustment of seat cushion*,
angle adjustment of seat base* and
seatbacks. Choose the following methods
according to the functions available in
your vehicle.
Seat position adjustment switch
●
Move the seat position adjustment
switch back or forth to move the seat
backward or forward.
●
Move the front end of the switch up or
down to change the seat base angle.
●
Move the rear end of the switch up or
down to raise or lower the seat.
75
03
CONTROLLER OPERATION