BYD SEAL U DM-i - Rear Seat Head Supports

REMINDER
●
Please fold or unfold the rear
seats at a moderate speed. Avoid
quickly lowering or pulling up
seatbacks to prevent damage to
or malfunction of rear seats and
the seat belts.
●
When unfolding a rear seat, do
not push the seatback hard;
otherwise, the seatback will be
pre-stressed and impossible to
unlock.
●
When unfolding a seatback, check
that the buckle position is proper
to expose the reserved opening
on the seat.
●
Do not turn over the seat when
the seat belt latch is inserted into
the buckle.
Rear Seat Head Supports
1. Lifting a head support
Lift the head support in the direction of
the head post until it is in the appropriate
position, and then release it until a
locking sound is heard.
2. Lowering the head support
Press the head support adjustment
button, lower the head support to a
proper position, and then release the
button.
3. Removing the head support
Press and hold the head support
adjustment button, remove the head
support, and release the button.
4.
Installing the head support
Insert the head support post into the
bushing with the grooves facing forward.
Press the head support adjustment
button, push down the head support to
a proper position, and then release the
button.
REMINDER
●
Head supports protect vehicle
occupants from head and neck
injuries. Adjust the head support
so that its centre aligns with
the back of your head for
maximum protection. Adjust the
head support to the proper
position based on your actual
height.
●
When adjusting head support
height, align the occupant's ear
tip line with the centre line of the
head support.
●
After adjusting the head support,
ensure that it is locked into
position.
●
Do not drive the vehicle without
head supports.
77
03
CONTROLLER OPERATION