●
Push up the lever to signal right turn.
The right turn signal and its indicator
on the instrument cluster ash.
●
Pull down the lever to signal left turn.
The left turn signal and its indicator on
the instrument cluster ash.
●
Once turned on, turn signals continue
ashing even after the lever is
released. They will turn o after the
turn is complete. Depending on the
driver's habit, the turn signal will reset
after the vehicle turns around under
some extreme conditions.
Auto light o
●
Conditions to activate the auto light o
function: To activate this function, set
the light switch to
or and switch
o the vehicle power.
●
With the auto o function activated,
if the driver's door is closed,
this function automatically turns o
headlights and position lights after 10
s.
●
With the auto o function activated,
if the driver's door is opened,
this function automatically turns o
headlights and position lights after 10
min.
●
After the lights turn o automatically,
if the light status changes, these lights
come on in the new status. If the
conditions to activate the auto light o
function are still met, the function is
activated again.
●
Disabling of the auto light o function:
When the vehicle is powered on, the
auto light o function is disabled,
and the light switch can be operated
normally.
●
The auto o function turns o the
lights. If the anti-theft state is activated
and then deactivated, the lights turned
o before are automatically turned
on again. If the driver's door is not
opened, this function turns o the
lights again after 10 s. But if any door
is open, it turns o the light in 10
minutes.
"Follow me home" function
●
Follow me home headlight:
●
The user can go to the "Follow me
home delay" setting interface via the
Infotainment
→ Vehicle settings
→ Light & ambient to set the time of
follow me home. The default time is
10 s. When the light switch is rotated
to the
, or position, and
the owner powers o the vehicle,
locks the four doors, and tries to
leave the vehicle, the corresponding
lights continue to light up for 10 s
(or a set time) to provide the lighting
source.
●
Headlights before entering:
●
The user can go to the "Follow me
home delay" setting interface via the
Infotainment
→ Vehicle settings
→ Light & ambient to set the time
of follow me home. The default
time is 10 s. When the light switch
is rotated to the
, or
position, and the owner unlocks the
vehicle and tries to get close to it,
the corresponding lights continue to
light up for 10 s (or a set time) to
provide the lighting source.
80
To Next Page
Loading...
