BYD SEAL - Page 139

●
After the vehicle starts, the image
before last power-o󽗈 is displayed on
the invisible panoramic view interface.
Foreign bodies in the underbody
and surrounding blind areas may be
inconsistent with the actual ones. The
underbody image will be updated in
real time only after the vehicle has
moved, which must be driven beyond
its length for a complete update.
WARNING
●
The panoramic view system
has transparent panoramic view
function to view the image below
the vehicle. This function is only
used to assist in observation of
area below the vehicle during
parking/driving. Investigation of
foreign objects below the vehicle
and dangerous situations should
be carried out in any other
manner to ensure the safety of
personnel and the vehicle.
●
When the vehicle runs at a low
speed, the transparent panoramic
view function is a󽗈ected by speed
󽗊uctuation or multiple stops,
so there will be misalignment
between the images below the
vehicle and that outside the
vehicle.
●
The panoramic view system is
only used for assisting parking/
driving. Parking or driving the
vehicle only depending on this
system is unsafe, because there
are some dead zones both in
front of and behind the vehicle.
Therefore, the surroundings of the
vehicle should also be observed
by other means during parking/
driving to avoid accidents.
●
As 󽗉sh-eye cameras are applied
to the system, some displayed
objects may be di󽗈erent from the
actual ones in shape.
WARNING
●
Do not use the panoramic view
system if side mirrors are not
extended in place. Make sure
that all doors are properly closed
when operating the vehicle with
the help of the panoramic view
system.
●
There may be some di󽗈erence
between the distance displayed
on the panoramic view interface
and the distance felt by the
driver. Especially when an object
gets closer to the vehicle, the
driver should judge the distance
between the vehicle and the
object by multiple means.
●
Cameras should be installed on
the front grille and side mirrors
and above the rear license plate.
Make sure the camera is not
blocked.
●
To prevent a󽗈ecting the
performance of cameras, avoid
directly washing these cameras
when washing the vehicle body
with high-pressure water. If there
is water or dust on the camera,
wipe it o󽗈 in time.
●
Do not knock the camera in
any way; otherwise, it will cause
malfunction or damage to the
camera.
●
After the vehicle is started, if the
infotainment system has not been
fully started, when the panoramic
view start button is operated or
the R button is pressed at this
time, the panoramic view display
interface output will be delayed
or "blinking screen" will occur.
This is a normal power-on process
when the camera is activated.
138