●
V2L enables the vehicle to supply
power to external devices. Vehicle-
to-load equipment* consists of a
discharging connector, a power strip,
a cable, and a discharging connector
protective cover.
WARNING
●
Do not touch any metal terminal
of discharging socket or vehicle
charge port during discharging.
●
Stop discharging immediately if
there are any abnormalities such
as peculiar smell and smoke.
●
See "Charging Instructions" for
charging safety warnings.
●
Store the product in a cool and
dry place when it is not in use.
●
When charging, do not place the
equipment in the trunk, under the
front of the vehicle, or near the
tires.
●
When using the equipment,
prevent it from getting rolled
over by the vehicle, dropped, or
trampled on.
●
Never drop the equipment or
move it by pulling it directly
by its cable. When moving the
equipment, handle it with care.
●
Never use the charging equipment
if the power strip cable becomes
soft, the charging connector cable
is worn out, the insulation layer
is cracked, or any other damage
occurs.
●
Never use the equipment
when the charging connector,
power plug, or power strip is
disconnected, broken, or there is
any sign of surface damage.
CAUTION
●
For precautions concerning use of
the discharge connection device,
please refer to the precautions for
charging equipment included in
item 3 of "Charging Precautions".
●
Before discharging, please
conrm the vehicle state of charge
(SOC; battery charge level) and
estimate the remaining driving
range.
●
Before V2L discharging, ensure
that the load is turned o.
REMINDER
●
The V2L function is recommended
only when SOC is high.
●
The V2L function is restricted
when the vehicle SOC is low.
●
When the vehicle is powered o,
the static power consumption
of the vehicle will increase
if the V2L connection
device is connected for an
extended period without any
output. Therefore, removing the
discharging/charging connector
when the device is not used is
recommended.
V2L Discharging
Starting discharging
●
Before discharging, disarm the anti-
theft alarm system.
●
Unlock the charge port door, then
open the port door and cap.
●
Check before discharging:
●
Ensure that the battery capacity of
the vehicle to be discharged is not
below 15%.
105
04
USING AND DRIVING
To Next Page
Loading...
