BYD TANG 2024 - Automatic Vehicle Hold (AVH)

WARNING
●
To prevent the vehicle from
moving, the gearshift is not to
be used to replace EPB when
parking. EPB must be used
instead, and the vehicle must be
in "P" gear.
●
The EPB switch must not be
operated when the vehicle is
moving.
●
When the EPB switch is pulled
or released, the brake pedal
must be pressed to prevent
the vehicle from moving, and
the subsequent locking of the
gearshift that occurs because
EPB cannot provide a su󽗋cient
parking force.
Automatic Vehicle Hold
(AVH)
Automatic vehicle hold (AVH): The
function is activated automatically when
the moving vehicle needs to be stationary
for longer periods of time, such as in
tra󽗋c jams on a slope or waiting at tra󽗋c
lights.
Slow-Moving Condition
●
When the gear is shifted into "R" and
the vehicle moves slowly, AVH goes
into slow-moving mode. When the
vehicle reverses (R gear) or travels (D
gear) at a low speed, AVH is suppressed
to improve vehicle motion.
●
To exit slow-moving mode, push the
AVH switch or drive at a speed above
10km/h. Then the AVH function can be
activated normally.
AVH Standby Preconditions (All Must Be
Met)
1. AVH switch is turned on and the white
AVH standby indicator is displayed on
the instrument cluster.
2.
The driver's seat belt is fastened and
the doors are closed.
3. The vehicle drive motor is started or
the ignition is on.
4.
Intelligent power braking system and
electrical park brake (EPB) systems are
normal.
CAUTION
●
The AVH defaults to o󽗈 once
the vehicle is powered up. When
AVH is in standby mode,
is displayed on the instrument
cluster.
AVH Running Conditions (All Must Be
Met)
1. AVH condition has been met.
2. In D gear, the brake pedal is pressed to
stop the vehicle.
●
The AVH function is enabled, brake
lights and the high mount brake light
are on, and the AVH indicator on the
cluster turns green.
●
The AVH function enters the standby
mode after working for 10 minutes,
with the EPB automatically engaged.
124