BYD TANG 2024 - Page 132

●
ICC activated:
●
The ICC system is operational.
It maintains the set speed or
automatically adjusts the distance
from the vehicle ahead. At this time,
is displayed on the instrument
cluster.
●
ICC failure:
●
There has been a failure in
the system. No operation can
be performed, and the ICC fault
indicator lights up on the
instrument cluster.
ICC Activation Conditions
●
The EPB has been released.
●
The vehicle is in Drive.
●
The vehicle does not slide backwards.
●
The trunk, hood, and all doors are
closed.
●
Driver seat belt is fastened.
●
The ESC system is on, but not activated
yet.
●
Vehicle speed is not greater than 120
km/h.
●
Brake pedal is pressed at speed 0; or
brake pedal is not pressed at speeds
above 0.
●
There is no vehicle network
communication failure prompt on the
instrument cluster.
●
The AEB function is not activated.
●
Two-way lane lines are clear and the
vehicle is at the center of the lane.
How to Use
●
Press the button ① on the steering
wheel to activate or exit ICC. (By
default, when the function is activated,
the current speed is set as the cruise
speed. If the current speed is below
30 km/h, the cruise speed is set to 30
km/h.)
●
For how to set the cruise speed and
vehicle distance, see ACC function
descriptions (in the previous chapter).
●
You can also turn ICC on or o󽗈 in
→ ADAS → Driving Assist. If ICC
has been enabled on the infotainment
touchscreen, it can be disabled only
when the vehicle is in P gear. When
the vehicle is just started up, ICC
status before the last power-o󽗈 is
maintained.
Precautions
●
ICC integrates ACC and LCC. Therefore,
ACC function precautions must be
followed during use (see the previous
chapters for details).
●
When ICC is turned on and activated
at vehicle speeds between 0 km/h and
120 km/h:
●
If there is no lane lines ahead,
transverse ICC control is suppressed
and only ACC works. In that case, ICC
working status indicator turns gray
on the instrument cluster.
●
If lane lines ahead are clear and
recognizable, transverse ICC control
is activated automatically. In that
case, ICC working status indicator
131
04
USING AND DRIVING