BYD TANG 2024 - Page 138

●
Targets are outside the mmWave
radar's detection range.
●
FCTA or FCTB is switched o󽗈.
●
The vehicle is not in Drive.
●
Four doors are open.
●
System initialization has not been
complete yet.
●
MmWave radar(s) fail.
●
Vehicles coming from the front left
or right side are detected too late at
sharp turns, slopes, or other settings.
●
In󽗊uence of vibration or collision on
mmWave radar sensor calibration can
degrade system performance. If this
is detected, contact a BYD authorized
dealer or service provider.
WARNING
●
FCTA/FCTB only serves as a
driving assistance function, so the
driver must be fully responsible
for driving safety.
●
In󽗊uence of weather, road
conditions, and other factors may
cause FCTA/FCTB to fail or lead to
late braking.
●
Use FCTA/FCTB based on
your needs, tra󽗋c, and road
conditions.
Tra󽗋c Sign Recognition
(TSR)
The tra󽗋c sign recognition (TSR) system
identi󽗉es speed limit signs through the
multi-purpose camera and map*, displays
such signs on the current road on the
instrument cluster, and sends alarm
messages to the driver when vehicle
speed exceeds the detected limit.
How to Use
●
Enable or disable TSR in
→ ADAS →
Safety Assist.
●
When the TSR system identi󽗉es the
current tra󽗋c sign, is displayed on
the instrument cluster.
●
When TSR cannot identify whether the
recognized speed limit value applies to
the lane,
is displayed.
●
When the TSR system experiences
reduced performance, is displayed.
●
When the TSR system has a reduced
performance and cannot identify
whether the recognized speed limit
value applies to the lane,
is
displayed.
●
If the TSR system malfunctions, is
displayed.
●
If you disable TSR manually by
pressing buttons,
is displayed.
●
When no available speed limit value
is identi󽗉ed, is displayed on the
instrument cluster.
●
The speci󽗉c numbers displayed in the
indicators depend on the actual tra󽗋c
signs.
Precautions
●
The tra󽗋c sign recognition system can
identify speed limit signs only, and will
not control speed. The control over
the vehicle always vests in the driver.
Please drive properly.
●
Weight limit signs not in standard
size as per national regulations may
mistakenly be identi󽗉ed as speed limit
signs.
●
If a speed limit sign is unclear,
distorted, inclined, re󽗊ective, or partly
blocked or overlaid, the multi-purpose
137
04
USING AND DRIVING