BYD TANG 2024 - Page 147

●
To enable or disable HUD, go
to infotainment touchscreen
→
Vehicle → HUD. By factory default,
the switch is toggled on and a HUD
image is displayed. When the switch is
toggled o󽗈, no HUD image is displayed.
The system defaults to the previous
settings when the vehicle restarts.
●
Height Adjusting: adjust the height
of HUD virtual image in between
-10 and 10. A total of 21 values are
available, and the default value is 0.
●
Brightness Adjusting: adjust the
height of HUD virtual image in
between 1 and 11. A total of 11 values
are available, and the default value is
6.
●
Whirling Adjusting: adjust the angle
of HUD virtual image. A total of 11
values are available, and the default
value is 0°.
●
Mode Setting: select Classic (default
setting) or Snow mode according
to the service environment of the
vehicle.
●
Settings optional for display: safe
driving assistance or navigation. They
are enabled by default.
CAUTION
●
Do not put articles on the head-up
display.
●
Wipe the dust on the dust-proof
board with soft cotton cloth or
paper towel.
CAUTION
●
No water or other liquid is allowed
to 󽗊ow into the opening of the
head-up display.
Driver Monitoring
Assistance
Driver monitoring assistance, including
fatigue and distraction warning, is
designed to monitor and assess the
driving status by taking photos of the
cabin with a camera. The photos will
not be saved or uploaded to the server.
Instead, they will be deleted immediately
after the judgement is complete. Based
on the assessment results, the system
gives a visual or audible alert to the driver
in a timely manner.
How to Use
●
The camera for driver monitoring
assistance is mounted on the A-pillar
of the driver's side. Make sure the
slide cover is open and the camera is
unobstructed before use. If the camera
is obstructed, no valid photos can
be taken although the camera is still
operational. Therefore, the function
fails to work properly.
●
Enable or disable this function in
→ Vehicle → Cabin Perception with
the ignition switched on. The system
is enabled by factory default and is on
when the vehicle restarts.
146