BYD TANG 2024 - Page 150

●
When the system is running, if a fault
occurs, the tire pressure fault warning
light is solid on after 󽗊ashing, and
the message "No Signal" or "Please
check the TPMS" is displayed on the
instrument cluster. In that case, check
the tire pressure monitoring module,
and check for any surrounding
electromagnetic source nearby. If the
alarm persists for a long time, please
contact a BYD authorized dealer or
service provider.
WARNING
●
If the tire pressure is not normal,
the system will not prevent the
vehicle from traveling. Therefore,
each time before driving, the
vehicle should be started statically
to check whether the tire pressure
meets the requirements speci󽗉ed
by the manufacturer. If not, do
not drive the vehicle. Otherwise,
the vehicle will be damaged or
personal injury will occur.
●
If pressure is found to be
abnormal while driving, check
the tire pressure immediately. If
the low pressure warning light
comes on, avoid sharp turns or
emergency braking, and reduce
vehicle speed, pull it over to the
curb and stop as soon as possible.
Driving with low tire pressure can
cause permanent damage to tires
and increase the likelihood of tire
scrapping. Serious tire damage
can lead to tra󽗋c accidents,
resulting in serious injuries or
deaths.
CAUTION
●
The running time of the tire
pressure monitoring module is
related to the daily travel distance
and other factors.
CAUTION
●
The tire pressure monitoring
module regularly transmits tire
pressure and other information
to the display. Therefore, if the
tire pressure drops suddenly or
there is a 󽗊at tire, the monitoring
module will not transmit data
to the display until the next
monitoring. In this case, the
vehicle may be out of control. If
there is a 󽗊at tire and monitoring
fails to inform, or if you feel that
there is some tire problems, stop
driving immediately instead of
waiting for the display to signal an
alarm.
●
If the tire pressure monitoring
module is installed incorrectly, it
will a󽗈ect the air tightness of the
tire. It is recommended that the
installation and replacement of
the pressure monitoring module
be carried out by professional
technicians of a BYD authorized
dealer or service provider in
accordance with the requirements
of the installation manual.
●
Since tire pressure varies with
regional temperatures, in󽗊ate
or de󽗊ate the tires according
to the values displayed on
the instrument cluster and the
standard tire pressure values.
●
If the vehicle is equipped
with non-BYD approved electrical
accessories, the tire pressure
monitoring system may be
disturbed, do not misunderstand
the disturbance as a tire pressure
system failure.
●
When replacing wheel rims or
spare tires* or performing tire
rotations, the tire pressure system
needs to be matched again.
149
04
USING AND DRIVING