EasyManua.ls Logo

BYD TANG 2024 - Reflective Vest

BYD TANG 2024
230 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
When Faults Occur
Re󽗊ective Vest
The re󽗊ective vest is in the tool kit.
In case of emergency, always wear
the re󽗊ective vest properly before you
check for faults or handle accidents to
ensure your safety.
If Smart Key Battery is
Exhausted
If the smart key indicator does not 󽗊ash
and the vehicle cannot be started using
the start function, the smart key battery
may be exhausted. It is recommended
to contact a BYD authorized dealer or
service provider for battery change as
soon as possible. In this case, you may
start the vehicle in no power mode.
CAUTION
Do not expose the smart key to
high temperatures.
Check for nearby radio stations,
substations or airport radio
transmitters that may interfere
with the normal operation of
electronic smart keys.
After locking the vehicle and
arming its anti-theft alarm
system, keep the key away from
the vehicle if you do not use the
vehicle; otherwise the automatic
card 󽗉nding of the vehicle will
consume the power of the low-
voltage battery and the smart key.
1. Use the mechanical key to unlock the
vehicle.
2. Put the smart key close to the no-
power sign on the auxiliary dashboard.
3. Press the START/STOP button and the
brake pedal to start the vehicle.
Emergency Shutdown
System
If the following conditions are met, the
emergency shutdown system will be
activated and the HV system will shut
down automatically:
Any air bag fails to deploy after a
front collision.
Some rear collisions.
Vehicle system failure.
If any of the above collisions and
vehicle system failures occur, the OK
indicator goes o󽗈.
Activating the emergency shutdown
system in the noted types of collision
minimizes the risk of injuries or
accidents. The vehicle system cannot
be switched into the OK status
once the emergency shutdown system
is activated. In that case, it is
recommended to contact a BYD
authorized dealer or service provider.
Even if the ignition switch is set to the
OK position, the system will be turned
o󽗈 immediately. It is recommended
to contact a BYD authorized dealer or
service provider as soon as possible.
206

Table of Contents

Related product manuals