BYD TANG 2024 - Page 212

WARNING
a󽗈ected body part immediately
with plenty of clean water.
●
Change contaminated clothing
immediately.
●
In case of an allergic
reaction, seek medical attention
immediately.
●
If tire sealant is ingested by
accident, rinse mouth thoroughly
and drink plenty of water
immediately. Do not induce
vomiting, but seek medical
attention immediately.
How to Use
●
Refer to labels on the in󽗊ator for usage
of the kit.
●
If the in󽗊ator needs to be connected
to a power source, plug the in󽗊ator
into the vehicle's 12V socket, start the
vehicle, and turn on the in󽗊ator. The
tire sealant is then 󽗉lled through the
in󽗊ator hose into the tire along with
air.
REMINDER
●
Make sure the in󽗊ator switch is
o󽗈 when you plugging the power
supply into the 12V socket in the
vehicle.
REMINDER
●
Do not use the in󽗊ator
continuously for more than 10
minutes at a time.
●
Before using the power plug,
make sure that its voltage and
power do not exceed the 12 V
and 120 W limits marked on the
backup power supply. Exceeding
these limits poses a safety hazard.
●
Observe the tire pressure reading on
the in󽗊ator.
●
If the tire pressure does not reach 180
kPa within 10 minutes (red area shown
in the 󽗉gure), turn o󽗈 the in󽗊ator. You
are recommended to contact a BYD
authorized dealer or service provider.
●
If the tire pressure reaches between
180 and 320 kPa (green and yellow
areas shown in the 󽗉gure), remove
the kit as soon as possible and drive
at a speed below 80 km/h within
one minute, with the furthest driving
distance not exceeding 10 km, so that
the tire sealant is evenly distributed
within the tire.
211
07
WHEN FAULTS OCCUR