BYD TANG 2024 - Page 25

WARNING
●
Where applicable to use a top
tether strap with the child
restraint system, ensure the strap
is routed through the hole in
the head support before attaching
and tensioning the strap to the
anchorage point at the base of the
seat.
●
Child restraint anchorages are
designed to withstand only
those loads imposed by correctly
󽗉tted child restraints. Under no
circumstances are they to be used
for adult seat belts, harnesses,
or for attaching other items or
equipment to the vehicle.
Second-row outboard and third-row
seats
●
The outboard seats on the second row
and the third-row seats are equipped
with ISOFIX/i-Size anchorages.
●
The anchorage locations are identi󽗉ed
by a marking (see illustration) located
on the seatback, directly above the
associated anchorages.
CAUTION
●
The anchorages are located in the
gap between the seat cushion and
the seatback.
●
The outboard seats on the second row
and the third-row seats are equipped
with tether strap anchorages on the
back.
Installing Child Restraint Systems with
ISOFIX Rigid Anchor
●
Child restraint
1.
Check the ISOFIX anchorage provided
on the second row outboard seat and
secure the child restraint to the seat
according to the labeled anchoring
position.
●
Install the child restraint on the seat.
2. Fasten the snap hook of the top
tether strap to the anchor support, and
tighten the top tether to ensure the
strap is secure.
●
Second-row seat installation position:
① Top tether
② Snap hook
③ Anchor support
24