BYD TANG 2024 - Page 59

REMINDER
●
When the vehicle is powered o󽗈,
the trunk can be unlocked from
the inside in case of emergency.
Setting trunk opening height
●
Open the trunk manually or
automatically to the desired position,
keep it at this position, and then press
and hold the interior trunk button
for over three seconds. The speaker
sounds for one second, indicating that
the opening height is successfully set
to the current position.
●
Set the trunk opening height by going
to the infotainment touchscreen
→
Vehicle → Locks.
Anti-pinch function
The trunk will open or stop moving if
it contacts any obstacle while closing or
opening.
When the trunk fails to act
automatically
Manually and completely close the trunk
for recovery.
When reconnecting the low-voltage
battery
Manually close the trunk to ensure the
power trunk functions normally.
WARNING
●
In order to prevent serious
injury, make sure to observe the
following precautions:
●
Never try to deliberately activate
the anti-pinch function.
●
Make sure to alert people nearby
of the lid motion.
●
Make sure hands and 󽗉ngers are
clear from the lid area when it is
closing.
●
Make sure the surrounding area
is safe when opening or closing
the trunk.
●
Make sure the trunk is properly
closed when the vehicle is in
motion.
●
Make sure to remove any ice
or snow from the area before
opening the boot, otherwise the
lid may close again.
●
Do not manually interfere in lid
motion when it is opening or
closing.
●
Be mindful of windy conditions
when opening or closing the
trunk.
●
The anti-pinch function may fail
to work if an object is caught
right before the trunk is fully
closed.
●
The lid may start closing
before fully opening. Opening
or closing the trunk on slopes
is more di󽗋cult than on level
ground. Be mindful of the
possibility of the lid to move
on its own in such conditions.
Before loading or unloading the
trunk, make sure the lid is fully
open and secure.
58